Medical Cold Patch
Patch For Diarrhea,Medicated Patches For Arthiritis,Plaster For Diarrhea,Pad For Diarrhea Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjplaster.com
Patch for diarrhea
[Name] Medical Cold Patch
[Package Dimension] 5cm 4pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give a fast relief for diarrhea.
[How To Use a Patch]
Please follow the Schematic Diagram. One piece, one time.
The curing effect of each piece can last for 6-8 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
Store below 30c in a dry place away from heat and direct sunlight.
A series of methods to pay attention to in the cleaning of 3D mixer
The three-dimensional mixer is a device that uses two or more kinds of mechanical force and gravity, and material mechanical equipment to be evenly mixed. During the agitation process, the contact surface area of ​​the material is increased to promote the chemical reaction and accelerate the physical change. The equipment can mix the powdery or granular materials with good flowability very uniformly, so that the mixed materials can achieve good results.
The cleaning process of the three-dimensional mixer is divided into: 1. Fix the fan in the door and blow it in. The staff of the three-dimensional mixer enters to wear long pants, and the skin should not be exposed! Wear a helmet and a mask. There must be two people in the staff, and one person enters one person to help. 2. Change work for half an hour; 3. Open the three-dimensional mixer to call the door and the warehouse door, blow it with the air pipe, and blow off the surface dust and accumulated material. 4. Unplug the 3D mixer air pipe or bend the air pipe. Make sure there is no air to the mixer. 5. According to the need, the blade can be turned manually to clean the dead corner. Install the nozzle after cleaning. 6. Open the brake; 7. Enter the three-dimensional mixer, first remove the nozzle with a wrench, and blow it with air. Then use a shovel to shovel the material on the wall and the blades.
During the operation of the three-dimensional mixer, the mixing barrel has multi-directional operation, which accelerates the flow and diffusion during the mixing process, and avoids the segregation and accumulation of the specific gravity of the material caused by the centrifugal force of the general mixer. Phenomenon, mixing without dead ends, can effectively ensure the quality of the mixture. The remaining two spaces of the mixing barrel of the machine are perpendicular to each other, and are respectively connected between the main and driven shafts connected by the three-dimensional moving rocker arm, and the mixing barrel is discharged from the feeding body of the cylinder body, the forward frustum, and the eccentric frustum. The end, the feed port and the discharge device are composed.
When the 3D mixer is operated correctly, it can ensure the smooth progress of the work and the safety of the employees. The reducer of the three-dimensional mixer must be replaced with new oil once every three months, and it is often used. The residual materials of the three-dimensional mixer should be cleaned in time. When the mixing slurry is assembled and disassembled, it should be lightly disassembled, stabilized and lightly placed to avoid deformation damage. If abnormal vibration or abnormal sound is found during use, stop the inspection immediately.