Many vegetable farmers have such a habit, in the cucumber production, watching the spread of chaos, it will be re-ordered again. However, I think: Do not wait until the cucumbers are scattered and then fall. It should be done earlier, and the height should be different when winter and summer seasons fall.

This starts with the temperature inside the shed. When the temperature is high, the cucumber grows. When the temperature is low, the cucumber grows weaker. During the deep winter, the temperature inside the shed is low, and the growth of the cucumber itself is slow. If there is even a cloudy day, the cucumber is prone to “heading”. At this time, when falling, it is necessary to grasp the principle of “little moving and not moving”. Generally, it is advisable to spread the cucumber to 1.6 meters or more. It is necessary to grasp the time before and after the two times. Do not wait for the cucumbers to be in a mess, then think of falling. In addition, because falling vines affect growing cucumbers, they will affect their normal growth more or less. Therefore, in the deep winter season, it is generally not more than 30 cm.

In summer and autumn, the temperature inside the shed is higher and the cucumber grows more prosperous. At this time, we must master the principle of “falling vines.” Therefore, the growth of cucumber is faster. Generally, it takes only once every 10 days or so. Each time it falls to 1.3 to 1.4 meters, because even if it falls slightly lower, it will not be able to The day can be picked up. However, although the growth rate of cucumber during this period is faster, it is better not to exceed 50 cm at each fall, so as not to affect the normal growth of cucumber.

In addition, when communicating with other vegetable farmers, I discovered that many vegetable farmers have tried to save time by making cucumbers very low, and some even less than one meter. I think it is very inappropriate. Because the vines are low and the leaves are small, directly affecting the photosynthesis of cucumbers and reducing the accumulation of organic matter will inevitably cause the cucumbers to reduce production. Because I learned from the newspaper that a cucumber has to perform normal photosynthesis and requires that the functional leaves must be maintained between 16 and 20, and when the cucumber falls to less than one meter, I count the number and the plant is at its best. There are also 10 functional leaves, the leaves are reduced by nearly half, and the corresponding production will be greatly reduced.

Disclaimer: Some articles in this website have been transferred from the Internet. If you are involved in third party legal rights, please inform this website. phone

USB Laser Distance Sensor

JRT usb interface distance sensor board adds a USB port to a Laser Distance Sensor, inexpensive laser distance measurement sensors, allowing customers directly using GBeacon-2.3-Fx.exe software to control the rangefinder sensor. Usb laser distance sensors are the the most popular model devices, it works by measuring the phase of an visible-red laser beam that reflects on the target. Usually, customers would like to choose CH341SER.EXE version to test.

USB Laser Distance Sensor,Distance Sensor,Laser Distance Sensor,Distance Measurement Sensors

Chengdu JRT Meter Technology Co., Ltd , https://www.rangingsensor.com