Sr Treatment Trolley,Color Selected Treatment Trolley,Medical Light Treatment Trolley,Hospital Artistic Treatment Trolley NANJING TIANAO MEDICAL INSTRUMENTS MANUFACTURE CO.,LTD. , https://www.tianaomedical.com
Trouble shooting and troubleshooting method
Fault phenomenon
cause of issue
Adjustment and elimination methods
The motor does not turn
1, the fuse is broken
2, the motor is broken
3, electrical control components are not good
1, replace
2, replace
3, check
Abnormal sound
1. Improper cooperation of each transmission gear
2, cam or coupling screw loose
3, the horizontal seal longitudinal pressure is too large
1, re-adjust
2, fastening
3, re-adjust
Poor sealing of the bag
1. The horizontal sealing mold has poor meshing
2, the mold tooth is not clean
3, the shaper is improperly adjusted
4, the material
5, packaging film quality questions
1, re-adjust
2, brush with copper
3, re-adjust
4, low packaging speed
5, replace
The bag is not sealed
1, set the temperature is too low
2, the heating parts burned
3, electrical components are not good
1, reset
2, replace
3, check
Bags are not edged
1. The deformer is deformed or defective
2, improper adjustment
1. Correct or replace
2, adjust
Bag sealing material
1, the cutting time is wrong
2, material changes, poor fluidity
3, the speed is too fast
1, re-adjust
2, replace the material
3, slow speed
Poor incision
1, cutter wear
2, the position of the cutter is improper
3, the horizontal seal mold pressure is not enough
1, replace the blade
2, re-adjust
3, re-adjust
Bag length for a while
Short bag for a while
1, the photoelectric head lens has dust
2, the printed pattern is not or motley
3, set the bag length is wrong
4, the drive is bad
5, the shaper resistance is large
1, rubbed in the net
2, replace the packaging film
3, reset
4, replace
5, dressing shaper
Pan shaking
Unstable operation
1, cam or coupling loose
2, scraper over low resistance card tray
3, open Xiao, closed Xiao improper position
4, the tray shaft bend
1, fastening screws
2, adjust the scraper
3, re-adjust
4, replace the tray axis
Unloading weight is not allowed
Heavy for a while
Light for a while
1. The upper and lower trays are not parallel
2, scraper over
3, the tray is shaking seriously
4, material changes, uneven
1, re-adjust
2, lower
3, adjust
4, replace the material