The automatic laminating machine is for the surface film of printed matter, such as for books, posters, color box packaging, handbags, etc. In response to the increasing global environmental awareness, oily laminating films will gradually be replaced by aqueous laminating films. The new automatic laminating machine designed by our company is suitable for the two kinds of water/oily glue and pre-coated film.

The head of the automatic laminating machine adopts the Feida head automatic conveying paper system, the pressing steel bar adopts the hot oil circulation heating system, the composite pressure adopts the air pressure device, the electrical system adopts the PLC programming control, and the cutting system is equipped with a knife and The rotary flying knife slitting device is equipped with an automatic delivery system at the rear of the laminating machine. The whole machine has a small footprint, high automation, easy operation and high stability.

Pre-use inspection analysis of automatic laminating machine:

It is best to check the rubber roller and grease on the rubber roller regularly, and wipe the glue and dust on the roller in time. Ensure that the appearance of the two rolls is clean. The surface of each roller should be cleaned, not only that, after each use of the machine, it is necessary to clean the machine immediately. Use glue thinner to wash and wipe the rollers with a soft towel. It is strictly prohibited to use a sharpener to scrape the surface of the roller. Every time you turn on the machine, you should wipe off the dust on the surface of each roller. Computer hot stamping machine and check whether the appearance of each roller of the machine is black, when the machine presents defects or abnormal dynamics, it is necessary to analyze the reason and eradicate it in time, and wait until the machine is all normal before letting it continue to operate.

The blade line of the automatic laminating machine scraping blade should be flat and flexible. When there are appearances such as roundabouts, mouths and curls, it should be trimmed and exchanged in time. Use a 0.15~0.20 mm manganese steel or offset printing machine blade. Exchanged according to the original standard. It is necessary to punctualize the lubricating parts of the machine's transmission parts and sliding surfaces to ensure that the machine is in excellent lubrication condition. In particular, the large bearing of the pressing roller suffers from high pressure and high temperature, and the lubricating oil is freely steamed and thrown away. High-temperature lubricating oil, so that it can operate normally under high temperature and high pressure. The automatic laminating machine slab formwork support uses a steel pipe bracket composed of a coupling piece and a steel pipe, and is gradually opened as a fastener type steel pipe bracket.