1, raw materials: strawberries, sugar, citric acid, sodium benzoate, pectinase.

2. Process flow: Raw material selection → Cleaning → Crushing Enzyme → Juice extraction → Degassing → Clarification → Blending → Sterilization → Canning → Sealing → Cooling → Finished products.

3, operation method

(1) Raw material selection: Fruits with good freshness, moderate maturity, normal flavor, no pests, and no mildew are to be selected.

(2) Cleaning: Soak it with 5% detergent for 3 minutes, then rinse with running water.

(3) Crushing and Enzymatic Addition: In order to increase the yield of juice, crushing is required and pectinase is added. The amount of pectinase used was 0.05% fruit weight. The optimal temperature for the enzyme action is 40-42°C and the action time is about 2 hours.

(4) Juice: Add 5% cotton seed shell filter aid to the broken strawberry slurry to increase the juice yield. The juicer is then squeezed using a capsule press and the macromolecular material is filtered off.

(5) Degassing: Degassing during degassing. Preheat after degassing to improve the effect of the enzyme.

(6) Clarification: After standing for a while, filter to obtain clear strawberry juice.

(7) Blending: Add sugar and citric acid for blending so that the sugar content is 11%-12%, the total acid is 0.79%, and 0.1% benzoic acid is added.

(8) Sterilization: The use of high-temperature instantaneous sterilization is good, 121 °C, 10 seconds. Or use pasteurization 76.6-82.2 °C, sterilization for 20-30 minutes.

(9) Canning: The packaging container should be sterilized first. Due to the high acid content of strawberries, the strawberries have a corrosive effect on tinplate cans. Therefore, acid-resistant materials must be used to prevent scratching the paint during processing. Sealed immediately after canning, cooling to below 40 °C, and then packaging, storage, inspection.

4, quality requirements: finished red or purple, uniform color, shiny; sweet and sour, with fresh strawberry flavor; clarified and transparent, does not allow the presence of suspended substances; sugar content of 11% -12%, acid content of 0.79 %.

Pain Relief Patch for neck shoulder, lower back and leg.
[Name] Medical Cold Patch
[Package Dimension] 10cm×12cm 2pieces/box
The pain relief patch is composed of three layers, namely, backing lining, middle gel and protective film. It is free from pharmacological, immunological or metabolic ingredients.
[Scope of Application] For cold physiotherapy, closed soft tissue only.
[Indications]
The patches give fast acting pain relief for strains, sprains, cramp, bruises, swollen areas or joint stiffness.
[How To Use a Patch]
Tear off the packaging bag and remove the patch. Remove the protective film and apply the patch on the skin. One piece, one time. The curing effect of each piece can last for 8-12 hours.
[Attention]
Do not apply the patch on the problematic skin, such as wounds, eczema, dermatitis,or in the eyes. People allergic to herbs and the pregnant are advised not to use the medication. If swelling or irritation occurs, please stop using and if any of these effects persist or worsen.notify your doctor or pharmacist promptly. Children using the patch must be supervised by adults.
[Storage Conditions]
 Store below 30c in a dry place away from heat and direct sunlight.

Pain Relief Patch For Neck Shoulder,Lower Back And Leg

Pain Relief Patch,Pain Relief Pad,Pain Relief Plaster,Neck Pain Relief Patch,Back Pain Relief Pacth

Shandong XiJieYiTong International Trade Co.,Ltd. , https://www.xjplaster.com