To obtain the film before using the fully automatic sealing machine, confirm the winding direction of the film, find the counterclockwise direction, and place it on the film rod to fix it. Pay attention to whether the front and rear fixed splints of the film are tightly combined with the film. If it cannot be tightly combined, use a utility knife to cut the inside of the film tube into a bevel. After putting on the film, use a tape to firmly attach the film to the receiving paper tube.

Automatic sealing machine specific steps:

Turn on the power, turn on the power switch, the indicator light is on, set the temperature controller to the predetermined temperature, and the green heating indicator lights up. When the upper hot plate reaches the predetermined temperature, the red constant temperature indicator light is on. (When the sealing machine is working, the electric heating device alternates in the heating and keeping state, so the green and red indicator lights are alternately displayed, which is a normal phenomenon).

Put the plastic cup into the lower mold slide plate and push the lower mold slide plate to the determined position by hand (if it is a fully automatic sealing machine or automatic sealing machine, after the plastic cup is placed, the lower mold slide will automatically enter), and press down. Seal the handle of the machine to the maximum stroke, hold it for 1~2 seconds, then slowly raise the handle and push it to the original position. Pull out the lower mold slide, take out the plastic cup, and put it into the final sealing rubber cup.

3-Ply Masks

surgical mask,medical mask,KN95 respirator,ffp2 respirator,3-ply surgical mask tie-on,meidcal protective respirator

Shandong Zhushi Pharmaceutical Group Co.,LTD , https://www.sdzs-medical.com