Fresh Bay Leaves,Dried Bay Leaves,The Bay Leaf,Bay Leaf Powder jiangmen city hongsing food co., ltd. , https://www.jmhongsing.com
1. Rolling type capping machine maintenance:
(1) Tour the equipment on a daily basis and make a record of the operation.
(2) Lubricate each lubrication point as required before starting and during operation.
(3) Direct contact with the aluminum cover Some parts shall be disassembled and cleaned once after each batch number is produced or every week.
2. Common causes and treatment methods of rolling type capping machine :
Rolling Capping Machine Maintenance and Common Troubleshooting
Roller Cladding Machine Maintenance and Common Troubleshooting (Applicable to 7 Rolling Antibiotic Glass Bottle Capping Machines)
Fault phenomenon
cause
Approach
Loose aluminum cover
1 three-rotary cutter head radial distance is slightly larger
2 rolling cap center compression spring is too loose
1 The radial distance of the three-rotating cutter head is slightly adjusted
2 tighten the compression spring screw
The aluminum cover is rolled out of the finished product to appear corrugated or skinned
1 three-rotor position and spring force are not adjusted in place
2 rolling cutter head wear or low hardness
1 corresponding adjustment
2 exchange of new cutter head
The capping head is unstable and shakes during movement
The machine does not stop by itself when there is no cover
Loose spindle locking mechanism
Photoelectric sensor damage or control system failure
Locking spindle locking mechanism
Exchange photoelectric head or maintenance control system
The machine does not stop when rolling
The limit switch is disabled or the push rod in the bottle dial is disabled.
Adjust the limit switch or the position of the push rod in the bottle inlet and outlet
The aluminum cover is not attached to the bottle mouth or the aluminum cover is continuously dropped
1 track left and right calipers and bottles are not aligned
2 rail left and right calipers spring loose
3 aluminum cover track position is too high
1Adjust the centering of the left and right calipers and the bottle mouth
2 tighten the left and right caliper springs
3 slightly adjust the position of the track
The cover is not clear or has a card cover
Adjust the clearance of the track or the end of the caliper
Adjust accordingly
The bottle is running poorly or has a lodging
The belt and the belt are badly damaged or the belt is about to be disconnected.
Replace the conveyor belt and timing belt
The machine is running normally, but the bottle dial stops rotating.
When the bottle inlet dial is caught by the bottle, the roller bottle insurance mechanism malfunctions.
Remove the bottle, turn the bottle dial to reset it, and eliminate the malfunction accordingly.
The center of the bottle is not good when it goes into the rolling stand
Serious wear and tear between the inlet and outlet bottle dials and the work guide plates
Replace the corresponding part