Hpmc Empty Vegetarian Capsules,Vegetarian Empty Capsule,Empty Color Vegetable Capsule,Medical Empty Vegan Capsules Ningbo Jiangnan Capsule Co., Ltd. , https://www.ningbocapsule.com
What are the environmental requirements for the automatic operation of the automatic pill making machine?
The work of the automatic pill making machine is relatively simple. It is mainly to apply its own sharp knife. It is cut by some traditional Chinese medicines in the working state you set, so it is said that the more important care for it is transferred. Going to the care of the knife. In fact, we should start from your initial choice, because some of the pelleting machines are steel knives and some are iron knives. I don’t think it is easy to be corroded. I don’t say everyone can understand, so the choice becomes very important. It is. Secondly, we should clean it in time after daily work to ensure that there is no danger of corroding the blade in the next work.
Of course, it is not enough for blade care. We should also take effective care of its body. Because some herbs contain water, it will inevitably splash on the fuselage during the cutting process. Therefore, for the sake of insurance, it is recommended to The body of the automatic pelletizer is also cleaned, so that we can make smaller losses.
The automatic pill machine is suitable for indoor temperature of -5 °C to +40 °C, relative humidity less than 90%, grid voltage amplitude fluctuation <10% rating, no conductive dust and corrosive metal gas around. Installed in a sunny and clean place in the factory, you can use the feet, padding, and must be grounded for safety.
Before starting the machine, check whether the oil level of the gearbox reaches the standard position; check whether the oil cup on the hopper is filled with cooking oil; check whether the pilling machine is aligned and tightened; whether the wine clearing system is unblocked and adjust the appropriate amount.
The guide wheel, the guide frame, the pelletizing knife, etc. are used for disinfection treatment with alcohol.
Turn on electric heating. The strip part runs for 3-5 minutes, and can be fed without any abnormality, and the strip is pushed out. Return to the hopper part, and then open the pellet part after the material is qualified. The feeding should be uniform during the operation.
If it is found that the stripping and pelleting are not synchronized, the knob can be adjusted, the pellet is made clockwise, and the counterclockwise pellet is slow.