High temperature shacks have a good grasp of the method

High temperature shack is an important measure to solve the problems of fungal diseases, bacterial diseases, root knot nematodes, soil compaction and acidification in soil-borne diseases. After high temperature suffocation, the diseases caused by continuous cropping, such as Phytophthora, Verticillium wilt, Fusarium wilt, gray mold, root rot, stem-based rot, virus disease, etc., are significantly reduced, and the damage caused by root-knot nematode disease is significantly reduced. The obstacles are effectively alleviated.

At present, most of the solar greenhouses enter the summer high-temperature leisure period, which is a good time for high temperature suffocation. Now answer the questions that growers are concerned about.

High temperature suffocating shed, is it really "dry", or "wet stuffy"?

Dry high temperature shacks refer to the shacks after the crops are pulled, without watering, and directly sealed in the greenhouse. The dry high temperature suffocating shed has little effect on killing pathogens and pests in the soil layer, so it is rarely used in actual production. The wet high temperature shack is a common shed disinfection measure in production. The principle is to water the greenhouse soil, and the heat conductivity of the water is higher than that of the soil, so that the soil tillage layer reaches a higher temperature. If you combine “dry stuffing” with “wet stuffing”, the effect of sterilization and pest control will be more thorough and comprehensive.

Simple sunburn shack is good? Or add organic fertilizer, straw fertilizer, lime nitrogen and other shacks?

Tests have shown that high temperature stagnation combined with fertilization effect is better. In particular, the combination of straw fertilizer and lime nitrogen is the best, which can reduce the use of chemical pesticides and reduce the harm of continuous cropping obstacles.

The specific compound treatment method is: clean the shed after the harvest of the upper crop, and evenly spread the straw such as corn and straw per acre (the finer the smash, the better) 2000~3000 kg, the lime nitrogen 40~80 kg, use the rotation The tiller turns the straw and lime nitrogen into the soil (20~30 cm deep), mixes evenly, and leveles the concrete. The surface of the soil is covered with mulch, and the ditch is filled with water until the shed is wet and there is water. During the shack, if the soil is short of water, it can be refilled once. The use of sunlight to rapidly heat up the greenhouse (surface temperature up to 70 ° C) for more than 20 days. After the suffocating shed, the film should be ventilated for 5-7 days, and the fertilizer such as biological fertilizer should be applied.

Does lime nitrogen need to be applied annually?

The lime-nitrogen high temperature stagnation technology is a comprehensive solution to the problem of soil continuous cropping obstacles. Due to the relatively high cost of lime nitrogen, the use of this technology is not universal, and it is mainly suitable for greenhouses or solar greenhouses with long-term planting diseases, serious continuous cropping obstacles, and root-knot nematode diseases. Considering the cost and control effect of lime nitrogen, it is recommended to use 60 kg per acre in production. Disinfect with lime nitrogen, usually once every two years.

In addition to lime nitrogen, are there other disinfecting drugs?

It is also possible to use a fungicide such as carbendazim or chlorothalonil wettable powder to control diseases. Each mu can be mixed with 50% carbendazim wettable powder 2~3 kg and 20~30 kg ammonium bicarbonate, and evenly spread on the ground, deep turning 15~20 cm. In addition, before the greenhouse was closed, carbendazim was sprayed once more on the inner surface of the shed and fumigation with 10% isopropanol to kill the germs and pests hiding in the wall. In production, the organic fertilizer can be fermented in advance, evenly applied into the shed, and then sprayed or applied to the surface of the manure and the soil, and the combination of fertilization, application, cultivation, and shacking can be received in one fell swoop. Awesome results.

Is the high temperature shack covered by a single film or is it covered with a double film?

The high temperature shack requires the shed to be closed, not only to close the venting vent of the shed, but also to cover the mulch on the shed floor. Many vegetable farmers do not cover the mulch, resulting in lower soil temperature and poor stagnation effect. The lethal temperature of the root-knot nematode is 55 ° C, and it dies in 10 minutes at 55 ° C. If the mulch film is not covered, the temperature of the deep layer of the soil is low, and it is difficult to achieve the effect of thorough sterilization and insecticide. Therefore, it is still good for double film coverage.

How much does high temperature shack irrigation affect the effect? Tests have shown that the soil water content is closely related to the effect of bactericidal and insecticidal, and the effect is too low to achieve the effect of sterilization and insecticide. Generally, 70% of the field water holding capacity is the best. Therefore, before the shed, the water must be flooded, so that the soil forms an oxygen-deficient environment, which is more conducive to killing pests and diseases. At the same time, pouring large water can also bring the soil salt to the deep layer of the soil, which can reduce the salt content of the soil.

After high temperature suffocation, must the soil be applied with biological fertilizer?

After high temperature, most of the harmful bacteria or beneficial bacteria will be killed. Therefore, after the end of the high temperature suffocating shed, biological fertilizer or bio-organic fertilizer should be added to increase the beneficial bacteria in the soil, protect the rhizosphere environment, and enhance the disease resistance of the plants.

Disclaimer: Some articles on this website are transferred from the Internet. If legal rights of third parties are involved, please inform this website. phone

Disposable Piercing Guide - WPTC10

Product Description

Disposable surgical medical products refer to items used in surgical operations, which are discarded after one use. These products are used to maintain a sterile environment and prevent the spread of infection during surgery.


Some common disposable surgical medical products include:
1. Surgical masks: used to cover the mouth and nose of medical staff during operations to prevent the spread of germs.
2. Surgical gowns: Medical staff wear these to protect their clothing from contamination during surgery.
3. Surgical Gloves: Healthcare providers wear these gloves to protect their hands from contamination during surgery.
4. Surgical Drape: Used to cover the patient and create a sterile field around the surgical site.
5. Surgical needles: Used to suture incisions and wounds during surgery.
6. Scalpel blades: These are used to make incisions during surgery.
7. Surgical Forceps: Used to grasp and manipulate tissue during surgery.
8. Surgical catheters: These catheters are used to drain fluids from the body during surgery.

Overall, single-use surgical medical products are critical to maintaining a sterile environment and preventing the spread of infection during surgery.

Disposable Use Puncture Guider,All Laparoscopic Instruments,Keyhole Surgery Instruments

Changzhou Weipu Medical Devices Co., Ltd. , https://www.wmlaparoscopic.com