2. The speed reducer should be cleaned before use, and the HJ-40 or HJ-50 mechanical oil should be added according to the oil quantity specified in the manual. During the use, the oil scale should be observed. The amount of oil should not exceed or be lower than the oil scale. It is low engraving line on the Zui high or Zui. At the same time, it should be noted that the vent plug on the reducer cover should not be blocked by dust or other debris to prevent the possibility of oil leakage due to increased oil pressure in the internal cavity of the reducer. 3. The reducer is an intermediate transmission mechanism. The driving gear shaft is driven by the power equipment, and the low speed shaft transmits power to drive the working machine. Therefore, the position of the three should be correct when installing. When using the coupling drive, ensure that the different axial degrees of the shaft line do not exceed 0.075 mm, and the skewness of the axis is not more than 30 degrees. When driving by other means, the correct installation position should be ensured. 4. After the reducer is installed, it should be operated under no-load operation to check that all parts of the mechanism are working properly before the load can work. In the case of full load operation, the temperature rise of the reducer should not exceed 40 degrees Celsius, but the high oil temperature of Zui should be lower than 60 degrees Celsius. If the temperature rise is too high or the sound is abnormal, stop the analysis of the cause and continue to use it after troubleshooting. 5. During the use of the reducer, check every half month, open the sight glass cover, check the tooth surface contact marks of the gear and related conditions. In the first half of the year, a comprehensive inspection should be carried out, the cover should be opened, and the wear of the tooth surface and the bearing should be thoroughly checked. If problems are found, measures should be taken to remove the condensation. 6. The seal of the reducer; the split surface of the reducer, and the cover cover of the embedded end cover should be coated with sealant to prevent leakage. Product name
Peeling, sorting, rinsing,disinfecting, dicing, breading starch, fried.
Product name Crisp Fried Food,Fried Crispy Bugles Snacks Food,Fried Crispy Snack Food,Fried Crispy Onion Food Laiwu Manhing Vegetables Fruits Corporation , https://www.manhingfood.com
Fried Garlic,fried garlic crisp,Crispy Fried garlic Flakes, Toasted Flavored Fried Garlic, Crispy fried garlic granules
Product description
Select the high quality Fresh, mature and clean garlic.
fried shallot,fried shallot crisp,Fried Onion crispy,Crispy Fried Onion Flakes,
Crispy fried onion
Product description
Select the high quality Fresh, mature and clean wholesome bulb of the Allium cepa.Peeling, sorting, rinsing,disinfecting, dicing, breading starch, fried.
Precautions for use of reducer in drying and mixing equipment
1. Use the reducer to select the power equipment that matches the power according to the load capacity table. The transmission mode can be determined according to the needs.