The automatic feeding machine is favored by fishermen because it saves time and effort and reduces the labor burden. However, the use of the feeding machine still needs to have the correct method, otherwise it will not be worth the candle. The correct use of the feeding machine requires the following:

First of all, the installation of the feeding machine should choose the appropriate position, should face the open side of the fish pond, so that the feeding surface is wide; the water level should be deep to facilitate the fish to eat. The two pools can be shared by a single feeding machine, the chassis is made active, and the direction can be turned; the distance and interval of the casting can be adjusted.

Secondly, it is necessary to manually feed one day a week, and record the food intake of the fish every time. This week, it can be put into the bait box according to this amount, and fed according to the prescribed amount. It is best not to increase or decrease at will. It is more appropriate to determine the amount of feeding once a week.

Again, pay attention to stop feeding on rainy days. In addition, when feeding the fish, the fisher should observe the eating condition of the fish; when the whole pool is disinfected every half month, check whether there is any bait residue at the bottom of the table. Don't expect to turn it on. When the machine is turned on, no matter how the fish eats, the machine feeds the same bait. When the fish is not eaten, the machine is still throwing, and the material sinks to the bottom, which is not only wasteful but also bad.

Finally, when purchasing a bait machine, you should purchase a manufacturer that feeds the bait machine. The products should be qualified by the technical supervision bureau, with good equipment, convenient maintenance, and economical and practical products. Paying attention to the following points: First, the appearance is beautiful, the paint color is bright, the volume of the material box is more than 50 kg, the thickness of the steel material of the material box is not less than 1.2 mm, the galvanized sheet is not less than 0.7 mm; the second is the power is not Less than 40 watts, no more than 120 watts, working noise bottom; Third, semi-automatic electronic controller, must have adjustable timing, fixed interval, fixed feeding time and other functions. The fully automatic type is a microcomputer, which is controlled by a liquid crystal clock. It can be programmed to feed -9 times a day, and the length of time can be set arbitrarily. (Jingmei)