Booting step of the packaging and transportation test machine

With Haida's continuous innovation in product technology, new products are emerging. In order to solve the operation problems of the majority of users on the packaging and transportation vibration machine. Haida engineers deliberately provide customers with the preparation and start-up steps of this equipment before operation.

First, the preparation work before the operation

The test operator must be familiar with and understand the Operational Use Guide.

Before the test, the initial function of the test sample should be tested. If there is a bad machine, it should be replaced.

Select the appropriate fixture based on the shape of the test sample.

After the test piece is installed on the table top, the height of the table top must be adjusted so that the table top screw plane is level with the table height indicator. If the screw plane is higher than the table height indicator, the inflation valve is deflated, if the screw plane is lower than the table height indicator Ruler, then inflated from the inflation valve

Second, the boot step

Before starting up, make sure that the gain knob position on the front panel of the vibration controller is zero and that the amplifier gain is in the reset position.

Turn on the power amplifier.

Open the power knob and microcomputer power switch on the front panel of the vibration controller.

Please pay attention to the above three points when you start the packaging and transportation test machine. If you need to know more, you can log in to our website or call us. We welcome you at any time and sincerely look forward to cooperating with you.